Usb Board - HP 17-p000 Maintenance And Service Manual

USB board

Description
USB board
Before removing the USB board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the base enclosure and top cover (see
Remove the USB board and cables:
1. Disconnect the USB cable from the ZIF connector (1).
2. Remove the Phillips screw securing the USB board (2), and lift the USB board (3) to remove it.
Reverse this procedure to install the USB board and cables.
Battery on page 30).
Optical drive on page
Base enclosure on page
31).
34).
Component replacement procedures
Spare part number
767120-001
49