Fan - HP Envy x360 Maintenance And Service Manual

4. Remove the board (4) from the computer.
To install the IR board, reverse this procedure.

Fan

To remove the fan, use this procedure and illustration.
Table 5-9 Fan descriptions and part numbers
Description
Fan
Before removing the fan, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
Remove the fan:
1. Remove the two Phillips M2.0 × 3.0 screws (1) that secure the fan to the computer.
2. Lift the tape (2) that covers the fan cable connector on the system board.
3. Disconnect the fan cable (3) from the system board.
42 Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page 30).
Spare part number
N86643-001
Battery on page 31).
30).