Syntax; Commands; List; Update - HP AB464-9003F Service Manual

3. Boot the system to the EFI Shell prompt. The CD drive should appear in the list of mapped
devices as fs0.
4. Change to this device by entering fs0: under the EFI Shell prompt.
5. If the EFI utility and firmware image files are not located in the root directory, move to the
directory in which these files are located, for example:
fs0:\>cd \EFI\HP\TOOLS\IO_CARDS\SmartArray
IMPORTANT:
directory. If they are not, copy them both to the EFI partition. Run the saupdate.efi using the
fs0:\> saupdate command.
If you are not using the Offline Diagnostic CD:
1. Download the SA EFI update utility saupdate.efi and copy it to the EFI partition.
2. Download the firmware and copy it to the EFI partition.
3. Boot the system to the EFI Shell and change directories to the EFI partition.
4. Run the saupdate.efi using the using the fs0:\> saupdate.efi command. The
following screen displays. The version of the utility displays on the second line:
*************************************************************
Smart Array Offline Firmware Update Utility
Version: 1.04.12.00
(C) Copyright 2004 Hewlett Packard Development Company L.P.
*************************************************************

Syntax

saupdate <operation> <parameters>

Commands

You can use the following operations with saupdate:

LIST

UPDATE

UPDATE all
HELP or?
List
Use LIST to display all detected Smart Array controllers along with the active firmware versions.
fs0:\> saupdate LIST
*************************************************************
Smart Array Offline Firmware Update Utility
Version: 1.04.12.00
(C) Copyright 2004 Hewlett Packard Development Company L.P.
*************************************************************
Seg Bus Dev
1 51 4
1 20 1
The identification information from this list is used to designate which controller is to be updated.
UPDATE
NOTE: The saupdate utility program file (saupdate.efi) must be located in the same file
system as the firmware files.
saupdate UPDATE [ <seg:bus:dev:func>] [smartarray_firmware_file]
Both saupdate.efi and the firmware image file must be located in the same
Func Description
0 HP Smart Array 6400
0 HP Smart Array 5300
Version
1.92
3.54
Smart Array P400, P600 and P800 Controllers 307