HP AB464-9003F Service Manual page 301

Operation
The number of disk drives in an IM array plus the hot spare disk cannot exceed three. You can
create only one hot spare disk. You must make sure the capacity of the hot spare disk is greater
than or equal to the capacity of the smallest disk in the logical drive. An easy way to verify this
is to use the DISPLAY command.
CAUTION: See rules for creating IM volumes and hot spare disks.
DELETE
The DELETE command sets the controller configuration to factory defaults. This command also
deletes any existing IR volumes.
Syntax
cfggen <controller #> delete [noprompt]
Parameters
<controller #>
[noprompt]
Operation
After entering the DELETE command, the system prompts you and asks if you want to proceed
with the command. Enter Yes if you want to proceed.
DISPLAY
This DISPLAY command displays information about controller configurations: controller type,
firmware version, BIOS version, volume information, and physical drive information.
Syntax
cfggen <controller #> display [filename]
Parameters
<controller #>
[filename]
Sample Output
Read configuration has been initiated for controller 0
------------------------------------------------------------------------
Controller information
------------------------------------------------------------------------
Controller type
EFI BSD version
Firmware version
Channel description
Initiator ID
Maximum physical devices
Concurrent commands supported
------------------------------------------------------------------------
IR Volume information
------------------------------------------------------------------------
IR volume 1
Volume ID
Status of volume
RAID level
Size (in MB)
Physical hard disks (Target ID)
------------------------------------------------------------------------
Physical device information
------------------------------------------------------------------------
A SAS controller number between 0 and 255.
Eliminates warnings and prompts.
A SAS controller number between 0 and 255.
Valid filename to store output of command to a file.
: SAS1068
: 2.00.09.00
: 1.10.01.00
: 1 Serial Attached SCSI
: 63
: 62
: 511
: 2
: Okay (OKY)
: 1
: 34304
: 9 1
HPE 8 Internal Port SAS HBA (SAS Controller) 301