HP AB464-9003F Service Manual page 303

Target ID
State
Size (in MB)/(in sectors)
Manufacturer
Model Number
Firmware Revision
Serial No
Drive Type
------------------------------------------------------------------------
Enclosure information
------------------------------------------------------------------------
Enclosure#
Logical ID
Numslots
StartSlot
Start TargetID
Start Bus
Logical drive status values:
Okay (OKY)
Degraded (DGD)
Inactive (OKY)
Inactive (DGD)
Physical device status values are as follows:
Online (ONL)
Hot Spare (HSP)
Ready (RDY)
Available (AVL)
Failed (FLD)
Standby (SBY)
FORMAT
The FORMAT command performs a low-level format of a disk drive. This operation can only be
performed on a hard disk drive. The drive cannot be an IR volume or a hot spare drive.
Syntax
cfggen <controller #> format <Encl:Bay> [noprompt]
Parameters
<controller #>
<Encl:Bay>
[noprompt]
Volume is Active and drives are functioning properly and user data is
protected if the current RAID level provides data protection.
Volume is Active and the user's data is not fully protected due to a
configuration change or drive failure; a data resync or rebuild may be in
progress.
Volume is inactive and drives are functioning properly and user data is
protected if the current RAID level provides data protection.
Volume is inactive and the user's data is not fully protected due to a
configuration change or drive failure; a data resync or rebuild may be in
progress.
The drive is operational and is part of a logical drive.
The drive is a hot spare that is available for replacing a failed drive in
an array.
The drive is ready for use as a normal disk drive or it can be, but has
not been, assigned to a disk array or hot spare pool.
The hard disk drive may or may not be ready, and it is not suitable for
inclusion in an array or hot spare pool (for example, it is not spun up, its
block size is incorrect, or its media is removable).
Drive was part of a logical drive or was a hot spare drive, and it failed.
It has been taken offline.
This status is used to tag all non-hard disk devices.
A SAS controller number between 0 and 255.
Enclosure number and Bay number that identifying the disk drive that will
be formatted.
Eliminates warnings and prompts.
: 9
: Online (ONL)
: 70007/143374738
: HP
: DG072A8B5C
: HPD4
: B062P5B010R10547
: SAS
: 1
: 500605B0:0001A950
: 8
: 1
: 0
: 0
HPE 8 Internal Port SAS HBA (SAS Controller) 303