Technics SX-KN7000 Operating Instructions Manual page 93

Part IV
<Measure 3>
(1) While playing an Am chord, press the
one time.
(2) While playing an F chord, press the key one
time.
<Measure 4>
(1) While playing a D7 chord, press the
one time.
(2) While playing a G7 chord, press the
one time.
• You can press the INTRO & ENDING button
or a FILL IN button on the panel to store the
desired pattern at the cursor position. (An
INTRO or COUNT INTRO can be stored only
at the beginning.)
• Store a rest by pressing a note value key
without specifying a chord.
5.
At the end of the chord progression, press the
End key ( ).
• The Keyboard exits the recording mode.
• During playback, playback of the recorded
chord progression stops at this point. For auto-
matic repeat playback of the chord progres-
sion, press the Repeat key (
the End key ( ).
• When you play back the track for the CHORD
part, the chords of the automatic accompani-
ment change in accordance with the stored
chord progression.
• To specify chords by the ONE FINGER mode,
select the ONE FINGER mode before entering
the STEP RECORD mode.
• If the ON BASS button is on, chords such as
"C on G" can also be specified (except in the
ONE FINGER mode).
• The CHORD FINDER feature, which shows
you how to finger a specified chord, is avail-
able. (Refer to page 57.)
Correct the recorded chord progression
key 1.
Follow the procedure to select the STEP RE-
CORD: CHORD display.
2.
Use the MEAS buttons to go to the measure
you wish to modify. Use the
rection keys to move the cursor to the point
(
*
• The lengths of rests are indicated by the re-
spective rest value × its multiplier.
Example:
..................1-beat rest (quarter rest)
• To go to the end of the chord progression,
key
while pressing the Reset key (
key
3.
Correct the chord data.
Chord data
When the chord name is displayed at the cursor
position, you can press the DELETE key to erase
the data and then store a new chord.
• If you do not erase the displayed data before
entering new chord data, the new data is in-
serted at this point, and the displayed data is
merely shifted by the note value of the new
chord.
• Rests can also be erased. Each time the DE-
LETE key is pressed, the rest is erased in
units of × 1. The
• If you wish to cancel the REPEAT, enter an
END command.
) instead of
Control data
The name of the stored function (INTRO, FILL,
etc.) is displayed. You can press the DELETE
key to erase the data which is displayed.
TRACK CLEAR
To erase all data from the current track, press
the CLR button, and then press the YES button
on the confirmation display.
• If you wish to cancel the clear procedure,
press the NO button.
) you wish to edit.
................1/2-beat rest (eighth rest)
× 1 +
....1-1/2-beat rest
(dotted quarter rest)
× 10 .........10-beat rest
key.
rest is erased last.
Sequencer
and Cor-
), press the
93
QQTG0671