Technics SX-KN7000 Operating Instructions Manual page 142

Part VII
SD-SOUND LOAD (SMF)
Load SD-SOUND (SMF) data from the SD card.
1.
On the LOAD (PAGE 1/3) display, press the
SD-SOUND button.
• The display looks similar to the following.
• For cards which contain SD-SOUND data only,
this display appears automatically when LOAD
is selected on the SD MENU display.
2.
Use the buttons below the display to select
the SONG name you wish to load.
• Use the PLAYLIST button to specify the
PLAYLIST (see page
SELECT button to specify the SONG.
• If you press the PLAYLIST EDIT button, the
display changes to the PLAYLIST EDIT dis-
play. (See page 145.)
• If you press the TECH button, the display
changes to the LOAD display for the TECH-
NICS SONG.
3.
Use the TO SONG button to select the number
to load to (this instrument's SEQUENCER
song number).
• Songs to load are specified one at a time.
• The SEQUENCER song name to load to is
shown below the TO SONG button.
4.
Use the LOAD AS button to specify the load
method.
• Select from the following.
GM/GM2 → GM2:
Activate the GM2 initialized settings, and
load GM/GM2 data.
NX → NX:
Active the NX SOUND settings, and load
NX data.
GM/GM2 → NX:
Activate the NX SOUND initialized settings,
and load GM/GM2 data.
PREV. TEC → NX:
Activate the NX SOUND initialized settings,
and load SMF data that was saved in the
TECHNICS mode on a previous model.
(The volume balance and octave settings
may differ from the saved settings.)
142
QQTG0671
145), the SONG
• If you select the setting which is different from
that in which the song was stored, the sounds,
octaves, and arrangement of percussion in-
strument sounds, etc. will be different.
5.
Press the LOAD button.
• The LOAD operation begins.
• When the operation has been successfully
completed, "COMPLETED!" is shown on the
display.
• If you press the START/STOP button, play-
back of the loaded data begins.
• During the LOAD operation, data that cannot
be processed by this instrument is ignored.
SD card