Technics SX-KN7000 Operating Instructions Manual page 31

Setting display
When you select an item from the menu display,
the setting display for the item is shown.
The buttons to the right, left and/or directly below
the display are used to select and adjust the set-
tings.
Example of setting display: MASTER
TUNING
MUTE
Press the button corresponding to the
ton on the display to change the value.
• In this manual, this procedure is written as
∧
follows: "Use the and
the pitch."
TEMPO/PROGRAM
If the TEMPO/PROGRAM indicator is lit while
you are using the display to adjust the setting, it
indicates that this dial can be used to quickly
change the displayed value or setting.
TEMPO/PROGRAM
• The setting which
highlighted on the display.
∧ ∨
or but-
∨
buttons to adjust
can be adjusted is
EXIT
While the setting display is shown, press this but-
ton to go back to the previous display.
DISPLAY
HOLD
EXIT
DISPLAY HOLD
Press this button to turn it on when you wish to
maintain the current display. You can keep a dis-
play which is normally automatically canceled,
for example, or even during a performance, you
can monitor information which is not shown on
the normal display.
DISPLAY
• The indicator for this button may flash if the
current display is one which is normally auto-
matically canceled.
• If the PROGRAM MENUS button, for example,
is pressed, the DISPLAY HOLD mode is can-
celed.
CONTRAST
Use the CONTRAST buttons to adjust the read-
ability of the display.
CONTRAST
• When adjusting the CONTRAST, the set value
is shown shortly on the display.
• If you want to keep the set value, press the
WRITE button. The instrument keeps the
memorized value even after the power is
turned off.
HOLD
EXIT
31
QQTG0671