Technics SX-KN7000 Operating Instructions Manual page 167

Part X
CHORD:
The sound is emphasized when chords are
played (like the cutting sound of a guitar, for
example).
TONE COPY
You can copy the tone of a particular sound to
a specified tone in the sound you are editing.
1.
On the 1/4 display, press the TONE COPY
button.
∧
2.
Use the FROM and
tone to copy from.
∧
• Use the OPTION
and
the item you wish to copy.
∧ ∨
3.
Use the TO and buttons to select the tone
you wish to copy to.
4.
Press the OK button.
• Tone copy is executed.
∨
buttons to select the
∨
buttons to select
KEY LAYER
Adjust the relation of tone output to keyboard lo-
cation.
1.
Use the PAGE buttons to view the 2/4 display.
• The display looks similar to the following.
2.
Use the buttons to the left of the display to
select a tone (1st, 2nd, 3rd or 4th).
∧
3.
Use the L-FADE and
∧ ∨
and buttons to define the area of the lower
range of tone output.
• By entering different values for the L-FADE
and LOW settings, you can define a sloping
volume increase to the peak output volume
which corresponds to the note pitch.
∧
4.
Use the HIGH and
∧ ∨
FADE and buttons to define the area of
the higher range of tone output.
• By entering different values for the H-FADE
and HIGH settings, you can define a sloping
volume decrease from the peak output which
corresponds to the note pitch.
• By overlapping the L-FADE and H-FADE
curves of each different tone, you can achieve
a cross-fade effect, where the sound gradually
changes in relation to pitch.
5.
Repeat steps 2 to 4 for the other tones, as
desired.
Sound Edit
∨
buttons and the LOW
∨
buttons and the H-
167
QQTG0671