Technics SX-KN7000 Operating Instructions Manual page 177

Part X
3.
Use the buttons below the display to assign a
name.
• Press the ABC button to enter alphabetical
characters. While the
pressed, upper case letters are entered.
• Press the 123 button to enter numbers, etc.
While the SHIFT button is pressed, you can
enter symbols.
• Press the POSITION button to move the cur-
sor.
• You can also use the TEMPO/PROGRAM dial
to select the characters.
• Press the INS button to enter a space at the
cursor position.
• Press the DEL button to erase the character
at the cursor position.
• Press the CLR button to erase the entire
name.
• Press the →← button to center the name.
4.
When you have finished typing the name,
press the OK button.
• The display returns to the MEMORY WRITE
display.
∧ ∨
5.
Use the and
MEMORY number in which to store the new
sound (1– 40).
6.
Press the OK button.
• The new sound is stored, and "COMPLETED!"
is shown on the display.
• The SOUND EDIT mode is turned off.
• The stored sound memories can be saved on
a disk/an SD card for recall at a later time.
(Refer to pages 130, 147.)
SHIFT button is
buttons to select the
Select a new sound
You can select your original sound just like the
other sounds in the SOUND GROUP.
1.
In the SOUND GROUP section, press the
MEMORY button.
MEMORY
• The list of sounds is shown on the display.
2.
Select the desired sound from the list on the
display.
Sound Edit
177
QQTG0671