Technics SX-KN7000 Operating Instructions Manual page 43

Part I
SOUND DSP
The SOUND DSP works like a studio effects pro-
cessor, providing effects such as CHORUS,
PHASER, DELAY and DISTORTION.
• There are five SOUND DSP groups, consisting
of three for RIGHT 1, RIGHT 2 and LEFT, and
two for the automatic accompaniment or
SEQUENCER.
1.
In the CONDUCTOR or PART SELECT sec-
tion, turn on the part to which this effect will
be applied.
2.
Press the SOUND DSP button to turn it on.
SOUND
DSP
• You can turn on the VARIATION button to
change the nuance of the effect.
• For the RIGHT 1, RIGHT 2 and LEFT parts,
when the DIGITAL DRAWBAR is on, this but-
ton is used to specify the tremolo effect type
(ROTARY SPEAKER/ROCK ROTARY).
Type and parameter settings
1.
Press and hold the SOUND DSP button for a
few seconds.
• The display changes to the following.
∧
2.
Use the PART and
SOUND DSP you wish to set.
• Only parts that can use the SOUND DSP can
be selected.
∧ ∨
3.
Use the and buttons to select an effect
group.
• The EFFECT MEMORY is for edited effects
(see below).
4.
Use the buttons to the left and right of the
display to select the type.
• If the types comprise more than one display
"page," use the PAGE buttons to switch pages.
VARIATION
∨
buttons to select the
∧
5.
Use the DEPTH and
depth of the effect.
• The depth does not change for some types.
• This display can also be accessed from the
REVERB & EFFECT MENU display. (Refer to
page 162.)
EFFECT EDIT
The effects can be edited and then stored in a
memory.
• MEMORY LIST is used to store all SOUND
DSP groups.
1.
Select an effect type to use as a base.
2.
Press the EDIT button.
• The display changes to the following.
Use the PARAMETER L and M buttons to
3.
select the parameter.
• Parameters with a (V) mark are effective when
the VARIATION button is turned on.
∧
4.
Use the VALUE and
setting.
5.
Press the NAMING button and assign a name
to the effect, if necessary.
• Refer to page 66
NAMING procedure.
Use the EFFECT MEMORY L and M buttons
6.
to specify the location in which to store the
edited effect.
7.
Press the WRITE button.
• The parameters vary depending on the effect
type selected as the base.
Sounds and effects
∨
buttons to set the
∨
buttons to adjust the
for details about the
43
QQTG0671