Understanding the printer menus
Use
Auto Color Detect
Color Sensitivity
1–9
Area Sensitivity
1–9
Allow color copies
On
Off
Sides (Duplex)
1 sided to 1 sided
1 sided to 2 sided
2 sided to 1 sided
2 sided to 2 sided
Paper Saver
Off
2 on 1 Portrait
2 on 1Landscape
4 on 1 Portrait
4 on 1Landscape
Print Page Borders
On
Off
Collate
On [1,2,1,2,1,2]
Off [1,1,1,2,2,2]
Punch
Off
2 holes
3 holes
4 holes
Staple
Off
On
To
Set the amount of color the printer can detect from the original document.
Note: This menu item is applicable only when Color is set to Auto.
Enable color in copies.
Notes:
•
On is the factory default setting.
•
Setting this to Off hides all color‑specific menus.
•
This setting overrides the Color setting.
Specify whether an original document is two‑sided or one‑sided, and then specify
whether the copy should be two‑sided or one‑sided.
Note: 1 sided to 1 sided is the factory default setting. This setting is selected when
using a one-sided original document for a one-sided copy job.
Copy two or four sheets of a document on one page.
Note: Off is the factory default setting.
Specify whether a border is printed.
Note: Off is the factory default setting.
Stack the pages of a print job in sequence when printing multiple copies.
Note: (1,2,3) (1,2,3) is the factory default setting.
Specify the type of hole punch finishing to be used.
Notes:
•
Off is the factory default setting.
•
This menu item appears only when a staple, hole punch finisher is installed.
Enable the staple finisher.
Notes:
•
Off is the factory default setting.
•
This menu item appears only when a staple finisher is installed.
169