Lexmark X790 Series User Manual page 166

Understanding the printer menus
Use
Location
Alarms
Alarm Control
Cartridge Alarm
Stapler Alarm
Hole Punch Alarm
Timeouts
Standby Mode
1–240
Timeouts
Sleep Mode
Disabled
1–240
Timeouts
Hibernate Timeout
Disabled
20 minutes
1–3 hours
6 hours
1–3 days
1–2 weeks
1 month
Hibernate Timeout on Connection
Hibernate
Do Not Hibernate
Timeouts
Screen Timeout
15–300
To
Specify the location.
Note: The location is stored on the Embedded Web Server.
Set an alarm when the printer requires user intervention.
For each alarm type, select from the following options:
Off
Single
Continuous
Notes:
•
Single is the factory default setting for Alarm Control. This
sounds three quick beeps.
•
Off is the factory default setting for Cartridge Alarm, Stapler
Alarm, and Hole Punch Alarm.
•
Continuous repeats three beeps every 10 seconds.
Set the amount of time before the printer enters a lower power
state.
Note: 15 minutes is the factory default setting.
Set the amount of time in minutes the printer waits after a job is
printed before it goes into a reduced power state.
Notes:
•
20 is the factory default setting.
•
Disabled appears only when Energy Conserve is set to Off.
•
Lower settings conserve more energy, but may require
longer warm‑up times.
•
Select a high setting if the printer is in constant use. Under
most circumstances, this keeps the printer ready to print
with minimum warm‑up time.
Set the amount of time the printer waits before it enters Hibernate
mode.
Note: 3 days is the factory default setting.
Set the printer to Hibernate mode even if there is an active Ethernet
connection.
Note: Do Not Hibernate is the factory default setting.
Set the amount of time in seconds before returning the control
panel to a Ready state.
Note: 30 is the factory default setting.
166