Installation: Panel Walls - Mira FORM Installation & User Manual

Installation: Panel walls

The Mira Form can be installed through a laminated panel or shower cubicle from
either the front or the rear of the panel. If fitted from the front the panel must have a
further finishing layer (e.g. plaster and tiles) applied to cover over the wall mounting
plate and fixing screws.
Rear Mounted (4 mm to 19 mm thickness)
To fit the Form shower control to the rear face of the panel, the panel thickness
(including plaster and tiles) must be between 4 mm and 19 mm.
1. Remove the control knobs and
building-in shroud from the valve. Refer
to section:
Removing/Fitting
Concealing Plate Assemblies. Put
the building-in shroud in the correct
position on the wall and draw around it
with a pencil. Cut out the hole in the
panel.
2. Peel off the backing on the adhesive
side of the foam outer seal and fix the
seal in the machined groove on the
back of the concealing plate.
3. Fit the compression nut and olive onto
the RAC elbow and fit to the valve.
Before tightening the compression
fitting make sure that the pipe is
pushed all the way into the valve
outlet and the elbow outlet is inline
with the control knobs, otherwise
the elbow will fail to line up with the
hole in the concealing plate. Fit the
outlet support bracket to the elbow and
secure with the wall clamp nut.
4. Using the valve as a template, mark
and drill the 6 fixing holes to secure
the mounting bracket and the outlet
support bracket in position. If no further
finishing surface is to be added to the
panel use the six inner fixing holes to
mount the valve. The concealing plate
will cover the fixing screws when fitted.
'Maintenance,
Knob and
19
Inner
Fixing
Holes
15 mm
Compression
Nut and Olive
RAC Elbow
Elbow Outlet