Stud Partition, Laminated Panel, Or Unfixed Rear-Entry Pipework Installation - Mira Coda Installation & User Manual

Stud Partition, Laminated Panel, or Unfixed Rear-entry Pipework Installation
For all installations using the Wall Mounting Bracket:
1. Install the pipework, make sure that
it is set at the correct distance apart
(150 ± 24 mm) and solidly fixed.
2. Screw the mounting brackets onto
the offset connectors.
The offset connectors must protrude
between 35 and 40 mm from the
finished wall.
3. The mounting bracket must extend in the same direction as the offset of the
offset connector. The angle between the offset connector and the mounting
bracket must be less than 45°, otherwise the mounting bracket will not fit under
the concealing plate.
Wall Mounting
Bracket
4.
The mounting bracket boss should protrude to the rear, facing the wall.
5. Apply suitable thread sealant (not supplied) and attach the offset connectors
to the pipework in the wall.
note! Connections are: Hot-Left, Cold-right. This is very important as this
product does not allow for reversed inlets.
10 mm
½" BSP Female
Connection
Support
Bracket
Pipework
Offset
Connector
Wall
Boss
Wall Mounting
Bracket
apply Silicone
Sealant
45°
45°
Spirit Level
Offset
Connector
12
150 ± 24 mm
Pipe Centres in Wall
Ø 27 mm
35 - 40 mm
150 mm