Mira FORM Installation & User Manual page 17

10. Fit the valve and connect the supply
pipework. Check the hot and cold
supplies have been connected to the
correct inlets. If necessary the valve
inlets can be reversed, refer to
Reversed Inlet Supplies for further
information.
Note! If the wall screws cannot be
fixed into the wall, fit the building-in
shroud and fill the cavity behind the
mounting bracket with an appropriate
material (e.g. expandible foam).
11. Fit the outlet support bracket over the
RAC elbow and mark the position of
the two fixing holes. Remove the
bracket and drill the two 6.0 mm
diameter fixing holes. Insert the wall
plugs and fit the outlet support bracket
with the fixing screws supplied.
12. Make sure that the protective cap is
fitted to the outlet on the RAC elbow,
and place the building-in shroud over
the valve.
13. Plaster and tile up to the edge of the
building-in shroud. Make sure that the
finished
somewhere between the two lines
marked on the shroud.
14. When the wall surface has been
completed, remove the building-in
shroud and outlet cap. If necessary,
cut the shroud to help removal.
15. Turn on the hot and cold supplies and
check for leaks.
16. Fit the concealing plate and secure with
the control knob and outlet assemblies.
Refer to section: 'Maintenance,
Removing/Fitting
Concealing Plate Assemblies.
wall surface
Knob
Outlet Support
Bracket
falls
Building-in Shroud
and
17
Hot and
Cold Inlets
Outlet
Protective
Cap