Table of Contents
Advertisement
Setting switch function list
No.
1
2
3
4
5
6
7
8
● Setting for beeper sound in the event of power failure, etc. (setting switch 1 )
... Factory setting: OFF
OFF: The beeper sounds when an alarm is necessary.
ON:
The beeper does not sound for backup operation or battery replacement. The beeper sounds for
other errors (connection capacity exceeded, operation error, etc.).
● Auto startup setting after recovery from power failure (setting switch 2 )
... Factory setting: OFF
OFF: Automatically starts when power is restored.
After a power failure occurs and the unit shuts down using the shutdown software or contact
signal(BS signal), the unit automatically starts and begins to output when the commercial power is
restored.
ON:
Does not automatically start when power is restored.
After the unit is shut down with the UPS monitoring software or contact signal (BS signal), it does
not start up when commercial power is restored. Startup is performed by turning the power switch
OFF once, and then back ON again.
Function to set
Setting for beeper sound in the
event of power failure, etc.
Auto startup setting after
recovery from power failure
Setting for whether or not to
perform battery test
Auto startup mode setting
---
---
BS signal valid range setting
---
ON
1
2
3
ON
1
2
3
OFF side
ON side
Beeper does
Beeper sounds
not sound
Do not perform
Perform auto startup
auto startup
Do not perform
Perform test
test
Mode B
Mode A
---
---
---
---
Valid only during
Always valid
Battery Mode
---
---
* In the factory settings, everything is OFF.
DIP
4
5
6
7
8
DIP
4
5
6
7
8
1002
3002
BU
SW / BU
SW
4
41
Hide quick links:
Advertisement
Table of Contents
