Sending A Message - Panasonic KX-TG1840AL Operating Instructions Manual

TG1840AL(e-e).book Page 43 Tuesday, April 11, 2006 11:02 AM
L Consult your service provider for more
information.
1
Press {j/OK}.
2
Select "SMS", then press {>}.
3
Select "Public", then press {>}.
4
Select "Settings", then press {>}.
5
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (page
38).
6
Select "Message Centre1" or
"Message Centre2", then press {>}.
7
Edit the number as necessary, then
press {j/OK}.
8
Select "Save", then press {>}.
9
Press {ih}.
Note:
L If your phone is connected to a PBX, you
need to add the PBX line access number
and a dialling pause to the beginning of
the Message Centre 1 phone number.

Sending a message

Writing and sending a new
message
1
Press {j/OK}.
2
Select "SMS", then press {>}.
3
To access the public mailbox
Select "Public", then press {>}.
To access a private mailbox
Select the desired mailbox, press {>},
then enter its password.
4
Select "Create", then press {>}.
L If "^Use Last Text?" is displayed,
you can use the text from the last
message you created by pressing
{e}. This message will be displayed
only if the last message was created
SMS (Short Message Service)
using the same mailbox you selected
in step 3.
5
Enter the message (page 48), then
press {j/OK}.
6
Enter the destination phone number (20
digits max.), then press {j/OK}.
L To send the message to a party saved
in the handset phonebook, press
{k}, select the handset phonebook
entry, then press {j/OK} 2 times.
L To send the message to a party logged
in the caller list, press {e} or {v}
repeatedly to select the party, then
press {j/OK} 2 times.
L To send the message to a phone
number logged in the redial list, press
{R} repeatedly to select the phone
number, then press {j/OK} 2 times.
L If you wish to send the message to the
other party's mailbox, enter the other
party's mailbox number after the
destination phone number.
Example: The other party's phone
number is 123456 and their mailbox
number is 1.
Enter 1234561.
If you do not enter the other party's
mailbox number, the message will be
sent to the public mailbox.
7
To save the message, select "Yes",
then press {>}.
L To send the message without saving it,
select "No", then press {>}.
8
To send the message, select "Send",
then press {>}.
L To cancel sending, press {ih}.
Note:
L This unit supports SMS messages of up to
612 characters, however, the maximum
number of characters you can send or
receive may be limited by your SMS
service provider. Consult your SMS
service provider for details.
43