Panasonic KX-TG1840AL Operating Instructions Manual page 71

TG1840AL(e-e).book Page 71 Tuesday, April 11, 2006 11:02 AM
Problem
"E0" is displayed.
"Q" is not displayed after you read
a message. An error code ("FD",
"FE", or "E0") is displayed.
Answering system
Problem
The other party complains that they
cannot leave a message.
I cannot operate the answering
system.
I cannot operate the answering
system remotely.
While recording a greeting
message or listening to messages,
the unit rings and recording stops.
Cause & solution
L Your phone number is permanently withheld or you
have not subscribed to the appropriate service.
Consult your service provider.
L When an error code is displayed, "Q" will not be
displayed even if you have read the message.
Cause & solution
L The recording time is set to "Greeting Only".
Select "1 Minute" or "3 Minutes" (page 56).
L Message memory is full. Erase unnecessary
messages (page 52).
L Another handset or the base unit user is using the
answering system, SMS features, accessing the
caller list or changing base unit settings. Wait for the
other user to finish.
L A caller is leaving a message. Wait for the caller to
finish.
L The handset is too far from the base unit. Move
closer.
L You are entering the wrong remote access code.
Confirm that the correct remote code is entered. If
you forget the remote access code, store a new
remote access code again (page 54).
L You are pressing the dial keys too quickly. Press
each key firmly.
L The answering system is turned off. Turn it on (page
55).
L You are using a pulse telephone. Try again using a
touch tone phone.
L A call is being received. Answer the call and try
again later.
Useful Information
71