Registering Mailboxes; Sending A Message - Panasonic KX-TG9120E Operating Instructions Manual

TG9120_40_50E(e).book Page 41 Wednesday, August 2, 2006 4:54 PM

Registering mailboxes

Each SMS mailbox you wish to use must be
registered with BT Text. There are two ways
you can register a mailbox:
– Send an SMS message to another
person.
– Send the text message 'REGISTER' to
destination number 00000.

Sending a message

Writing and sending a new
message
1
J (centre of joystick) i X i L
2
To access the public mailbox
"Public" i L
To access a private mailbox
Select the desired mailbox. i L i
Enter its password.
3
"Create" i L
L If "^Use Last Text?" is displayed,
you can use the text from the last
message you created by pushing the
joystick up.
4
Enter the message (page 55). i L
L j is displayed.
5
Enter the destination phone number (20
digits max.). i L
L Using the handset phonebook:
n i Select the handset
phonebook entry. i M
When only 1 phone number is
stored
L
When 2 or more phone numbers are
stored
Select the desired phone number. i
L 2 times
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
SMS (Short Message Service)
X
L Using the caller list:
Push the joystick up or down to select
the party. i L 2 times
L Using the redial list:
Press j repeatedly to select the
phone number. i L 2 times
L If you wish to send the message to the
other party's mailbox, enter the other
party's mailbox number after the
destination phone number.
Example: The other party's phone
number is 123456 and their mailbox
number is 1.
Enter 1234561.
6
To save the message, select "Yes". i
L
7
To send the message, press L.
L To cancel sending, press {ih}.
Note:
L This unit supports SMS messages of up to
612 characters, however, the maximum
number of characters you can send or
receive may be limited by your SMS
service provider/telephone company.
Consult your SMS service
provider/telephone company for details.
L If your message contains over 160
characters, the message is divided into
multiple messages (up to 4). You can
confirm how many messages are required
to send your text by the number shown on
the display ("1", "2", "3", or "4"). The
remaining number of characters that can
be entered is displayed next to j. Your
service provider/telephone company may
treat long messages (messages over 160
characters long) differently from other
messages. Consult your service
provider/telephone company for details.
L If your phone is connected to a PBX, store
the PBX line access number (page 44).
41