Panasonic KX-TG1840AL Operating Instructions Manual page 69

TG1840AL(e-e).book Page 69 Tuesday, April 11, 2006 11:02 AM
Problem
Static is heard, sound cuts in and
out. Interference from other
electrical units.
Noise is heard during a call.
The handset/base unit stops
working while being used.
While storing an entry in the
phonebook or assigning a one
touch dial, the handset starts to
ring.
Pressing {R} does not
display/dial the last number dialled.
The handset beeps intermittently
and/or 7 flashes.
I fully charged the batteries, but
7 still flashes.
Caller information is not displayed. L You must subscribe to Caller ID service.
While viewing caller information,
the display returns to standby
mode.
I cannot set call restriction.
Cause & solution
L Locate the handset and the base unit away from
other electrical appliances.
L Move closer to the base unit.
L Your unit is connected to a telephone line with
ADSL service. We recommend connecting a filter
(contact your ADSL service provider) to the
telephone line between the base unit and the
telephone line socket.
L You are using the handset or base unit in an area
with high electrical interference. Locate the handset
and base unit away from interference sources, such
as antenna and mobile phones.
L Disconnect the AC adaptor and turn off the
handset. Connect the AC adaptor, turn on the
handset and try again.
L A call is being received. To answer the call, press
{C}. Programming will be cancelled. Start again.
L The redialled number was more than 24 digits long.
Redial the number manually.
L Fully charge the batteries (page 14).
L Clean the charge contact and charge again (page
14).
L It is time to replace the batteries (page 15).
L Your unit is connected to a telephone line with
ADSL service. We recommend connecting a filter
(contact your ADSL service provider) to the
telephone line between the base unit and the
telephone line socket.
L Caller has withheld information.
L Do not pause for over 1 minute while searching.
L Call restriction can be set using handset 1 only. If
you have multiple handsets, you can confirm which
handset is handset 1 by pressing {x} and {1} on
the base unit. Handset 1 will start ringing.
Useful Information
69