Panasonic KX-TG1840AL Operating Instructions Manual page 56

TG1840AL(e-e).book Page 56 Tuesday, April 11, 2006 11:02 AM
Answering System Features
2
Select "Answer System", then press
{>}.
3
Select "Settings", then press {>}.
4
Select "Number of Rings", then
press {>}.
5
Select the desired setting, then press
{>}.
6
Press {ih}.
For Telstra Homeline service subscribers
To receive Voice Mail and use answering
system properly, please note the following:
L "Voice Mail" is a service provided by your
Service Provider. You will need to first
subscribe or activate this service through
your Service Provider. Consult your
Service Provider on how to operate this
service and how you will be notified that
you have messages on your Voice Mail.
To use this service you will be required to
leave your answering machine off on your
unit.
This will allow the Voice Mail to receive
any messages.
This unit does not have a visual indicator
to indicate if there are new messages in
your Voice Mail service. Your Service
Provider may use a "Stutter" dial tone to
indicate that you have Voice Mail left.
L To use the unit's answering machine
rather than the Voice Mail service
provided by your Service Provider, please
consult your Service Provider to have it
removed or deactivated permanently or
temporarily.
Alternatively you can leave this service
connected and change the "Number of
Rings" to a shorter duration on your unit
so your unit's answering machine can pick
up the call prior to the Voice Mail provided
by your Service Provider.
56
Note:
L Provider Voice Mail can capture
messages that can be missed while the
customer is on the Internet.
Selecting the caller's recording
time
You can change the maximum message
recording time allotted to each caller, or set
the unit to greet callers but not record
messages.
1
Press {j/OK}.
2
Select "Answer System", then press
{>}.
3
Select "Settings", then press {>}.
4
Select "Recording Time", then press
{>}.
5
Select the desired setting, then press
{>}.
6
Press {ih}.
Note:
L When the message recording time is set
to "Greeting Only", d and "--" are
displayed on the base unit.
Turning call screening on/off
While a caller is leaving a message, you can
screen the call through the speaker of the
base unit and the handset.
1
Press {j/OK}.
2
Select "Answer System", then press
{>}.
3
Select "Settings", then press {>}.
4
Select "Call Screening", then press
{>}.
5
Select "On" or "Off", then press {>}.
6
Press {ih}.