Turning The Power On/Off; Setting The Date And Time - Panasonic KX-TG1840AL Operating Instructions Manual

TG1840AL(e-e).book Page 16 Tuesday, April 11, 2006 11:02 AM
Preparation
1
Press the notch on the handset cover
firmly and slide it in the direction of the
arrow.
2
Remove the old batteries positive (S)
terminal first and install the new ones.
See page 14 for battery installation.

Turning the power on/off

Power on
Press {ih} for about 1 second.
L The display will change to the standby
mode.
Power off
Press {ih} for about 2 seconds.
L The display will go blank.

Setting the date and time

Important:
L Confirm that the AC adaptor is connected.
L Ensure that w is not flashing.
1
Press {j/OK}.
2
Select "Handset Setup", then press
{>}.
3
Select "Time Settings", then press
{>}.
4
Select "Set Date & Time", then press
{>}.
16
5
Enter the current day, month and year by
selecting 2 digits for each.
Example: 17 May, 2005
Press {1}{7} {0}{5} {0}{5}.
6
Enter the current hour and minute by
selecting 2 digits for each.
L You can select "AM", "PM" or 24-hour
time entry by pressing {*} repeatedly.
Example: 3:30 PM
Press {0}{3} {3}{0}, then press {*}
repeatedly until "03:30 PM" is
displayed.
7
Press {j/OK}.
8
Press {ih}.
Note:
L To correct a digit, press {<} or {>} to
move the cursor, then make the
correction.
L The date and time may be incorrect after a
power failure. In this case, set the date
and time again.