Nortel WLAN Access Port 223x Quick Installation Manual page 39

Step 5: Installing the Ceiling-Mount Bezel Kit (Optional) and Nortel WLAN — Access Port
Figure - 16.
Bracket from Plenum Side Showing Adjustment Screw Locations
14. Route the CAT-5, Ethernet cable and optional power supply to where they can plug into the Nortel WLAN —
Access Port (223x). Ensure to leave about 6 inches (15 cm) of slack in the cables for future modifications.
Note that using an optional power supply instead of Power of Ethernet (PoE) requires that the power supply
cable be fully enclosed in a metal conduit to meet safety requirements.
Cable Plugged into the Nortel WLAN — Access Port (223x) as Viewed from the Plenum Side.
Figure - 17.
Note:
Note:
WLAN Security Switch 2270 (Green Power and Yellow 802.11b/g and/or 802.11a LEDs lit), the
Nortel WLAN — Access Port (223x) begins broadcasting its beacon signals. When this happens,
complete the installation as quickly as possible to remove yourself from within 8 inches (20 cm) of
the Nortel WLAN — Access Port (223x) to comply with FCC RF radiation exposure guidelines.
You have installed the WLAN — Access Port (223x) and Bezel Kit.
Ensure the cables are routed away from the Nortel WLAN — Access Port (223x) antennas.
When the Nortel WLAN — Access Port (223x) is powered up and is associated with a
Nortel WLAN — Access Port (223x) Quick Installation Guide