Nortel WLAN Access Port 223x Quick Installation Manual page 32

32 Flush Wall Mount
Figure - 9.
Assembling the WLAN — Access Port (223x) to the Projection-Mount Bracket
• Attach the cables to the sides of the WLAN — Access Port (223x).
Note:
Note:
Security Switch (2270) (Green/Power and Yellow/802.11b/g and/or Yellow or Amber/802.11a
LEDs lit), the WLAN — Access Port (223x) begins broadcasting its beacon signal(s). When this
happens, complete the installation as quickly as possible to remove yourself from within 8 inches
(20 cm) of the WLAN — Access Port (223x) to comply with FCC RF radiation exposure guidelines.
You have installed the WLAN — Access Port (223x). Repeat
(223x) on page 26
for each WLAN — Access Port (223x) location, and then continue with
Information on page 41
Flush Wall Mount
When you are mounting the WLAN — Access Port (223x) against a wall (flat side toward the inside of the building), use
an optional separately-orderable factory-orderable flush-mount bracket.
216394-B Rev 00
Ensure the cables are routed away from the WLAN — Access Port (223x) antennas.
When the WLAN — Access Port (223x) is powered up and is associated with a WLAN —
.
Flush Wall Mount
Step 4: Mounting the WLAN — Access Ports
Step 6: Returning MAC