Nortel WLAN Access Port 223x Quick Installation Manual page 33

• Before proceeding, gently screw the two factory-supplied screws and spring washers into the bottom of the
WLAN — Access Port (223x). Ensure the spring washers have their convex (high center sections) pointing
toward the screw heads.
Note:
overtighten the screws, or the bracket will not fit under the screw heads.
Figure - 10.
Assembling the Mounting Screws and Spring Washers to the WLAN — Access Port (223x)
• Copy the MAC address(es) from the label(s) on the WLAN — Access Port (223x) onto the corresponding
location on the map. MAC addresses have the format 000B85xxxxxx.
• You have already attached the flush-mount bracket to the wall in
.
on page 24
• Slide the screws into the keyhole slots on the mounting bracket as shown in the following figure.
Note:
wall. This ensures that the correct antenna is facing the building, and makes future upgrades easier.
Note:
adjust the screws until they securely hold the bracket.
The WLAN — Access Port (223x) threaded holes have precision-depth threads. Do not
Ensure the side of the WLAN — Access Port (223x) with the door is facing away from the
If the screws do not securely hold the bracket, remove the WLAN — Access Port (223x) and
Nortel WLAN — Access Port (223x) Quick Installation Guide
Flush Wall Mount 33
Step 3: Preparing Mounting Locations