Nortel WLAN Access Port 223x Quick Installation Manual page 31

Projection Wall Mount
When you are mounting the WLAN — Access Port (223x) out from a wall (flat sides along the wall or hallway), use an
optional separately-orderable factory-orderable projection-mount L-bracket.
• Before proceeding, gently screw the two factory-supplied screws and spring washers into the bottom of the
WLAN — Access Port (223x). Ensure the spring washers have their convex (high center sections) pointing
toward the screw heads.
Note:
the screws, or the bracket will not fit under the screw heads.
Figure - 8.
Assembling the Mounting Screws and Spring Washers to the WLAN — Access Port (223x)
• Copy the MAC address(es) from the label(s) on the WLAN — Access Port (223x) onto the corresponding
location on the map. MAC addresses have the format 000B85xxxxxx.
• You have already attached the projection-mount L-bracket to the wall in
Locations on page 24
• Slide the screws into the keyhole slots on the mounting bracket as shown in the following figure.
Note:
the screws until they securely hold the bracket.
Projection Wall Mount
The WLAN — Access Port (223x) threaded holes have precision-depth threads. Do not overtighten
.
If the screws do not securely hold the bracket, remove the WLAN — Access Port (223x) and adjust
Nortel WLAN — Access Port (223x) Quick Installation Guide
Projection Wall Mount 31
Step 3: Preparing Mounting