Step 4: Mounting The Wlan - Access Ports (223X) - Nortel WLAN Access Port 223x Quick Installation Manual

26 Step 4: Mounting the WLAN — Access Ports (223x)
Step 4: Mounting the WLAN — Access Ports (223x)
Using the supplied or optional separately-orderable WLAN — Access Port (223x) mounting kits, mount each WLAN —
Access Port (223x) in its indicated location, oriented as shown on the map. Note that you can mount the WLAN —
Access Ports (223x) in the ceiling plenum or below the ceiling, but the WLAN — Access Ports (223x) perform best
when mounted below the ceiling.
Note that the Nortel 2200 Series supports Antenna Sectorization, which can be used to increase the number of clients
and/or client throughput in a given air space. Installers can mount two WLAN — Access Ports (223x) back-to-back and
the Nortel 2200 Series operator can disable the second antenna in both WLAN — Access Ports (223x) to create a
360-degree coverage area with two sectors.
The WLAN — Access Ports (223x) can be mounted in one of three configurations:
•
Ceiling-Mount Base on page 26
•
Ceiling-Mount Clips on page 28
•
Projection Wall Mount on page 31
•
Flush Wall Mount on page 32
•
Ceiling-Mount Bezel Kit (Optional) on page 34
Ceiling-Mount Base
When you are mounting the WLAN — Access Port (223x) in the middle of a ceiling (flat sides toward the room or
hallway), use the ceiling-mount base to mount the WLAN — Access Port (223x) as shown in the following figure and as
described below:
216394-B Rev 00
Ceiling Mount Base
Step 4: Mounting the WLAN — Access Ports (223x)