Table of Contents
Advertisement
Installing an Optional Tray
You can increase the paper handling capacity of your machine
4
Remove the memory DIMM from its antistatic package.
by installing an optional Tray 2. This tray holds 250 sheets of
Locate the alignment notches on the bottom edge of each
paper.
DIMM.
1
2
Connection
points
5
Holding the memory DIMM by the edges, align the notches
on the memory DIMM with the grooves at the top of the
memory DIMM slot.
3
6
Push the DIMM straight into the DIMM slot until it snaps into
place. Make sure the latches fit over the notches located on
either side of the DIMM.
Latch
Downloaded from ManualsPrinter.com Manuals
Setting Tray 2 in the Printer Properties
If you installed Tray 2 with your machine on, the machine does
not recognize it. In this case, you need to set the tray in the
printer properties window so that you can use it for PC printing.
The procedure for setting the tray may differ depending on the
selected printer driver.
To set the tray in the printer properties of the PCL 6 printer
driver:
N
: Printer driver does not support Windows 95.
OTE
Turn the machine off and unplug all cables from the
1
Click the Windows Start menu.
machine.
2
For Windows 98/Me/NT 4.0/2000, select Settings and then
Remove the packing material from the tray and remove the
.
Printers
tape fixing the interface cable to the tray.
For Windows XP, select Printers and Faxes.
3
Select the Printer Driver Type 103 PCL 6 machine icon.
4
Click the right mouse button on the machine icon and select
.
Properties
5
Click the Printer tab, and select Tray 2 from the Optional
Tray drop-down list.
Find the location of the connector and the optional tray
positioners.
Notch
6
Click OK.
Notches
Groove
Notch
B
Advertisement
Table of Contents
