Table of Contents
Advertisement
Cleaning the Drum
If there are streaks or spots on your print, the OPC drum of the
toner cartridge may require cleaning.
3
Unpack the new toner cartridge and gently roll it
1
horizontally 5 or 6 times to distribute the toner evenly
inside the cartridge.
2
Redistributing Toner
When the toner cartridge is near the end of its life, white streaks
or light printing occurs. The LCD displays the warning message,
"Toner Low." You can temporarily reestablish print quality by
ing the Scan Unit
3
redistributing the remaining toner in the cartridge. In some
case, white streaks or light printing still occurs even after you
the scan unit clean helps ensure the best possible
have redistributed the toner.
We suggest that you clean the scan unit at the start of
Save the box and the plastic bag for shipping.
y and during the day, as needed.
1
Open the front door.
4
Your Machine
htly dampen a soft lint-free cloth or paper towel with
N
:
OTES
er.
• If toner gets on your clothing, wipe it off with a dry cloth and
wash clothing in cold water. Hot water sets toner into fabric.
t quality, follow the cleaning procedures below
n the document cover.
5
• Do not touch the green underside of the toner cartridge. Use the
oner cartridge is replaced or if print quality
handle on the cartridge to avoid touching this area.
You can set your machine to clean the OPC drum automatically
e the surface of the document glass and ADF glass until
every 500 print pages. You should use this feature if you use
clean and dry.
4
Hold the toner cartridge by the handle. Slowly insert the
inferior quality paper, because such paper may lower print
cartridge into the opening in the machine. Tabs on the sides
quality.
abinet of the machine with cleaning materials
of the cartridge and corresponding grooves within the
e amounts of alcohol, solvent, or other strong
sheet
machine will guide the cartridge into the correct position
1
discolor or crack the cabinet.
until it locks into place completely.
the inside of the machine, be careful not to touch
ler, located underneath the toner cartridge. Oil
2
F glass
2
Pull the toner cartridge out and gently roll the cartridge 5 or
ers can cause print quality problems.
6 times to distribute the toner evenly inside the cartridge.
3
he Outside
et of the machine with a soft lint-free cloth. You
Groove
cloth slightly with water, but be careful not to
N
OTE
ip onto or into the machine.
4
he Inside
Downloaded from ManualsPrinter.com Manuals
e the underside of the white document cover and white
In the Select Notification section
In this section, you can select various settings.
• Consumable Shortage Warning: select Off not to send
the consumable shortage warning mail or After the
remaining level is approximately 20% to send e-mail
Setting E-mail Notification
when the remaining items are almost at the end of their
life.
This feature allows you to know your machine's status through
N
: Remaining level will follow in system and there is a
OTE
your e-mail. To set E-mail Notification, you need to enter some
possibility this percentage being different.
information in the Web Image Monitor Type 103.
• Consumable Status Report: select Off not to send the
In the Web Browser address bar, enter your machine's IP
consumable status report mail or Every 1000 pages to
address you assigned. Then the Web Image Monitor Type 103
send e-mail after printing 1000 pages. The mail contains
Before starting the cleaning procedure, make sure that
opens. It is consist of the Information, Machine Setup, Network
information about firmware version, toner count and
paper is loaded in the machine.
Settings, Maintenance and support tabs.
currently installed option.
Press Menu on the control panel until "Maintenance"
• Alert System Error: check the option you want to know
Setting the Machine Setup tab
appears on the top line of the display.
when error occurs.
The first available menu item, "Clean Drum," displays on
Select the Machine Setup tab and then configure the E-mail
the bottom line.
Notification option.
You may see the following window.
Press Enter.
The first available menu item, "Yes" displays on the bottom
line.
Press Enter.
The machine prints out a cleaning page. Toner particles on
the drum surface are affixed to the paper.
If the problem remains, repeat steps 1 through 4.
Press Menu on the control panel until "Maintenance"
appears on the top line of the display.
Document cover
In the Server Information section
Press the scroll button ( or ) until "Auto Cleaning"
In this section, you can enter your machine's network
appears on the bottom line and press Enter.
information.
Document glass
Press the scroll button ( or ) until "On" appears on the
• IP Address or Host Name: select IP Address or Host
display.
Name. IfG you select host name, you need to enter your
DNS setting inG the TCP/IP of Network Settings tab.
: For users in Asian countries, this feature is preset to "On."
• SMTP Server and Port: enter your SMTP Server Host
name or SMTP Server IP address and port thatG will be used
to connect to the SMTP Server. Port is from 1 to 65535.
Press Enter.
The Default Value is 25.
The machine will print out an OPC cleaning page every 500
print pages.
Tab
Advertisement
Table of Contents
