Table of Contents
Advertisement
• DHCP: Dy
• BOOTP: B
Printing a Network Configuration Page
8
From the Details tab, select the printer port and click OK.
The Network Configuration page shows how the network
interface card on your machine is configured. The default
In Windows NT 4.0/2000/XP
settings which are suitable for most applications are enabled.
1
Setting Up the Host Computer
1
Start Windows.
2
2
For Windows NT 4.0/2000, from the Start menu, select
Settings and then Printers.
3
For Windows XP, from the Start menu, select Printers and
Faxes.
3
Double-click your machine icon.
4
4
From the Printer menu, select Sharing.
5
For Windows NT 4.0, check the Shared box.
Setting Network Protocols
For Windows 2000, check the Shared As box.
When you first install the machine, all supported network
For Windows XP, check the Share this printer box.
protocols are enabled when you turn the machine on. If a
network protocol is enabled, the machine may actively transmit
6
Fill in the Shared Name field and click OK.
on the network even when the protocol is not in use. This may
increase network traffic slightly. To eliminate unnecessary
traffic, you can disable unused protocols.
Setting Up the Client Computer
1
1
Right-click the Windows Start button and select Explorer.
2
Open your network folder in the left column.
2
3
Click the shared name.
3
4
For Windows NT 4.0/2000, from the Start menu, select
Settings and Printers.
4
For Windows XP, from the Start menu, select Printers and
Faxes.
5
5
Double-click your machine icon.
Downloaded from ManualsPrinter.com Manuals
6
From the Printer menu, select Properties.
An IP add
7
Press the scroll button ( or ) to enter a number between
0 and 255 and press Enter or Upper Level to move
between bytes. Enter a number using the number keypad
and use the scroll button ( or ) to move between bytes.
8
Repeat step 7 to complete the address from the 1st byte to
Press Menu until you see "Network Setup" on the top line
the 4th byte.
of the display.
9
Press Enter.
Press the scroll button ( or ) until "Print Net CFG"
displays on the bottom line.
10
To select other parameters, such as a Subnet Mask or a
Gateway, press the scroll button ( or ) until the desired
Press Enter.
item displays on the bottom line. Press Enter.
The first available menu item, "Yes," displays on the bottom
11
Repeat steps 7 through 9 to configure the other TCP/IP
line.
parameters.
Press Enter.
12
Press Clear/Stop to return to Standby mode.
The Network Configuration page (NETWOR PRINTER CARD
TEST PAGE) prints out.
Dynamic Addressing (BOOTP/DHCP)
To have the TCP/IP address assigned automatically by the
server, take the following steps:
1
Press Menu until you see "Network Setup" on the top line
of the display.
2
Press the scroll button ( or ) until "Config Network"
appears on the bottom line.
Press Menu until you see "Network Setup" on the top line
3
Press Enter.
of the display.
The first available menu item, "TCP/IP," appears on the
bottom line.
Press the scroll button ( or ) until "Config Network"
displays on the bottom line.
4
Press the scroll button ( or ) to display "DHCP" on the
bottom line and press Enter.
Press Enter to access the menu.
5
To assign the address from the BOOTP server, press Enter
Press the scroll button ( or ) until you see the desired
when "BOOTP" displays on the bottom line.
protocol on the bottom line.
Press Enter.
If you selected "TCP/IP," assign a TCP/IP address. For
details, see page A.6.
Enter a number between 0
and 255 for each byte.
A
Advertisement
Table of Contents
