Checking The Front Differential Oil Level (Four Wheel Drive Models Only); Checking The Torque Of The Wheel Nuts - Toro workman HDX-D 07368 Operator's Manual

1. Clean the area around the filler neck and the cap
of the hydraulic tank (Figure 21). Remove the cap
from the filler neck.
Figure 21
1. Cap
2. Remove the dipstick (Figure 21) from the filler neck
and wipe it with a clean rag. Insert the dipstick into
the filler neck; then remove it and check the fluid
level. The fluid level should be between the two
marks on the dipstick.
3. If the level is low, add the appropriate fluid to raise
the level to the upper mark. Refer to Changing the
High Flow Hydraulic Fluid
4. Install the dipstick and cap onto the filler neck.
5. Start the engine and turn on the attachment. Let
them run for about two minutes to purge air from
the system. Stop the engine and attachment and
check for leaks.
Important: The vehicle must be running
before starting the high flow hydraulics.
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury.
• Make sure all hydraulic fluid hoses and
lines are in good condition and all hydraulic
connections and fittings are tight before
applying pressure to the hydraulic system.
• Keep your body and hands away from pin
hole leaks or nozzles that eject high pressure
hydraulic fluid.
• Use cardboard or paper to find hydraulic
leaks.
• Safely relieve all pressure in the hydraulic
system before performing any work on the
hydraulic system.
• Seek immediate medical attention if fluid is
injected into your skin.
Checking the Front
Differential Oil Level (Four
Wheel Drive Models Only)
Service Interval: Every 100 hours/Monthly
(whichever comes first)
The differential is filled with Mobil 424 hydraulic oil.
1. Position the vehicle on a level surface.
2. Clean the area around the fill/check plug on side of
the differential (Figure 22).
1. Fill/check plug
3. Remove the fill/check plug and check the level of
the oil. The oil should be up to hole. If the oil is
low, add Mobil 424 hydraulic oil.
4. Install the fill/check plug.
Checking the Torque of the
Wheel Nuts
Service Interval: After the first 2 hours
After the first 10 hours
Every 200 hours
Failure to maintain proper torque of the wheel
nuts could result in failure or loss of a wheel
and may result in personal injury.
Torque the front and rear wheel nuts to 80 to
90 ft-lb (109 to 122 N-m) after 1 to 4 hours of
operation and again after 10 hours of operation.
Torque every 200 hours thereafter.
24
Figure 22
2. Drain plug