Fuel System Maintenance; Fuel Lines And Connections; Servicing The Water Separator/Fuel Filter - Toro workman HDX-D 07368 Operator's Manual

4. Apply a light coat of clean oil to the new filter seal
before screwing it on.
5. Screw the filter on until the gasket contacts the
mounting plate, then tighten the filter 1/2 to 2/3 of
a turn. Do not overtighten.
6. Add oil to the crankcase; refer to Checking the
Engine Oil Level.
Fuel System
Maintenance

Fuel Lines and Connections

Service Interval: Every 400 hours/Yearly (whichever
comes first)
Every 1,000 hours/Every 2 years
(whichever comes first)
Inspect the fuel lines and connections for deterioration,
damage, or loose connections.
Servicing the Water
Separator/Fuel Filter
Draining the Water Separator
Service Interval: Before each use or daily—Drain water
or other contaminants from the water
separator.
1. Place a clean container under the fuel filter
(Figure 49).
2. Loosen the drain plug on the bottom of the filter
canister.
1. Water separator filter canister
3. Tighten the drain plug on the bottom of the filter
canister.
Changing the Fuel Filter Canister
Service Interval: Every 400 hours—Replace the fuel
filter canister.
1. Drain the water from the water separator; refer to
Draining the Water Separator.
2. Clean the area where the filter canister mounts
(Figure 49).
43
Figure 49