Cisco WAP551 Administration Manual page 82

LAN
Port Settings
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
Cisco Small Business WAP551 and WAP561 Wireless-N Access Point
Select LAN > Port Settings in the navigation area.
Port Settings
The Operational Status area shows the type of port used for the LAN port and the Link
characteristics, as configured in the Administrative Settings area. If the settings change
through configuration or auto negotiation, you can click Refresh to show the latest settings.
Enable or disable Auto Negotiation.
• When enabled, the port negotiates with its link partner to set the fastest link speed and
duplex mode available.
• When disabled, you can manually configure the port speed and duplex mode.
If autonegotiation is disabled, select a Port Speed (10/100 Mb/s for the WAP121, and 10/100/
1000 Mb/s for the WAP321) and the duplex mode (Half- or Full-duplex).
Enable or disable the Green Ethernet Mode. When enabled, the WAP device automatically
enters a low-power mode when energy on the line is lost, and it resumes normal operation
when energy is detected.
Enable or disable Green Ethernet Mode (WAP321 only).
• Green Ethernet Mode is an auto-power-down mode that reduces chip power when the
signal from a link partner is not present. Green Ethernet Mode works whether the port
has auto-negotiation enabled or disabled.
• When Green Ethernet Mode is enabled, the WAP device automatically enters a low-
power mode when energy on the line is lost, and it resumes normal operation when
energy is detected.
Click Save. The changes are saved to the Startup Configuration.
4
53