Cisco WAP551 Administration Manual page 183

Captive Portal
Instance Configuration
Cisco Small Business WAP551 and WAP561 Wireless-N Access Point
- Local—The WAP device uses a local database to authenticated users.
- RADIUS—The WAP device uses a database on a remote RADIUS server to
authenticate users.
• Redirect—Specifies that CP should redirect the newly authenticated client to the
configured URL. If this option is clear, the user sees the locale-specific welcome page
after a successful verification.
• Redirect URL—Enter the URL (including http:// or https://) to which the newly
authenticated client is redirected if the URL Redirect Mode is enabled. The range is
from 0 to 256 characters.
• Away Timeout—The amount of time a user remains in the CP authenticated client list
after the client disassociates from the WAP. If the time specified in this field expires
before the client attempts to reauthenticate, the client entry is removed from the
authenticated client list. The range is from 0 to 1440 minutes. The default value is 60
minutes.
An away timeout value is also configured for each user. See the
NOTE
page. The away timeout value set on the Local Users page has precedence over the value
configured here, unless the value is set to 0 (the default). A value of 0 indicates to use
the instance timeout value.
• Session Timeout—The time remaining, in seconds, for the CP session to be valid. After
the time reaches zero, the client is deauthenticated. The range is from 0 to 1440 minutes.
The default value is 0.
• Maximum Bandwidth Upstream—The maximum upload speed, in megabits per
second, that a client can transmit traffic when using the captive portal. This setting limits
the bandwidth at which the client can send data into the network. The range is from 0 to
300 Mbps. The default value is 0.
• Maximum Bandwidth Downstream—The maximum download speed, in megabits per
second, that a client can receive traffic when using the captive portal. This setting limits
the bandwidth at which the client can receive data from the network. The range is from
0 to 300 Mbps. The default value is 0.
• User Group Name—If the Verification Mode is Local or RADIUS, assigns an existing
User Group to the CP instance. All users who belong to the group are permitted to
access the network through this portal.
• RADIUS IP Network—The IP version that the RADIUS server uses. You can toggle
between the address types to configure IPv4 and IPv6 RADIUS address settings, but the
WAP device contacts only the RADIUS server or servers of the address type you select
in this field.
9
Local Users
142