Cisco WAP551 Administration Manual page 146

Client Quality of Service
Configuring VAP QoS Parameters
STEP 5
Cisco Small Business WAP551 and WAP561 Wireless-N Access Point
A nonzero configured value is rounded down to the nearest 64 Kbps value for use in the
AP, but to no less than 64 Kbps. A value of 0 means that the bandwidth maximum limit
is not enforced in this direction.
• ACL Type Down—The type of ACL to apply to traffic in the outbound (down)
direction, which can be one of the following:
- IPv4—The ACL examines IPv4 packets for matches to ACL rules.
- IPv6—The ACL examines IPv6 packets for matches to ACL rules.
- MAC—The ACL examines Layer 2 frames for matches to ACL rules.
• ACL Name Down—The name of the ACL applied to traffic in the outbound (down)
direction.
After switching the packet or frame to the outbound interface, the ACL's rules are
checked for a match. The packet or frame is transmitted if it is permitted, and discarded
if it is denied.
• ACL Type Up—The type of ACL to apply to traffic in the inbound (up) direction, which
can be one of the following:
- IPv4—The ACL examines IPv4 packets for matches to ACL rules.
- IPv6—The ACL examines IPv6 packets for matches to ACL rules.
- MAC—The ACL examines Layer 2 frames for matches to ACL rules.
• ACL Name Up—The name of the ACL applied to traffic entering the AP in the inbound
(up) direction.
When a packet or frame is received by the AP, the ACL's rules are checked for a match.
The packet or frame is processed if it is permitted, and discarded if it is denied.
• DiffServ Policy Down—The name of the DiffServ policy applied to traffic from the AP
in the outbound (down) direction.
• DiffServ Policy Up—The name of the DiffServ policy applied to traffic sent to the AP
in the inbound (up) direction.
Click Save. The changes are saved to the Running Configuration and to the Startup
Configuration.
7
113