Cisco WAP551 Administration Manual page 207

Single Point Setup
Access Points
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 1
STEP 2
STEP 3
Cisco Small Business WAP551 and WAP561 Wireless-N Access Point
Go to the web-based configuration utility on the standalone access point.
Select Single Point Setup > Access Points in the navigation pane.
Set the Cluster name to the same name that is configured for the cluster members.
(Optional) In the Location field, enter a description of where the access point is physically
located, for example, Reception.
(Optional) In the Priority field, enter a value between 0 to 255.
Click Enable Single Point Setup.
The access point automatically joins the Single Point Setup.
Removing an Access Point from a Single Point Setup Cluster
Removing an Access Point from a Single Point Setup
To remove an access point from the Single Point Setup cluster:
In the table showing the detected devices, click the IP address for the clustered WAP device
you want to remove.
The web-based configuration utility for that WAP device shows.
Select Single Point Setup > Access Points in the navigation pane.
Click Disable Single Point Setup.
The Single Point Setup status field for that access point will now show Disabled.
10
160