Cisco WAP551 Administration Manual page 184

Captive Portal
Instance Configuration
STEP 6
Cisco Small Business WAP551 and WAP561 Wireless-N Access Point
• Global RADIUS—This field is available if the Verification Mode is RADIUS. By
default, the CP instance uses the global RADIUS settings that you define for the WAP
device (see RADIUS
different set of RADIUS servers. To use the global RADIUS server settings, ensure that
the check box is selected. To use a separate RADIUS server for the CP instance,
uncheck the check box and enter values in the Server IP Address and Key fields that
follow.
• RADIUS Accounting—Enables tracking and measuring the resources a particular user
has consumed, such as system time and amount of data transmitted and received. If you
enable RADIUS accounting, it is enabled for the primary RADIUS server, all backup
servers, and globally or locally configured servers.
• Server IP Address 1 or Server IPv6 Address 1—The address for the primary RADIUS
server for this CP instance. When the first wireless client tries to authenticate with the
WAP device, the WAP device sends an authentication request to the primary server. If
the primary server responds to the authentication request, the WAP device continues to
use this RADIUS server as the primary server, and authentication requests are sent to
the address you specify. The IPv4 address should be in a form similar to
xxx.xxx.xxx.xxx (192.0.2.10). The IPv6 address should be in a form similar to
xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx (2001:DB8::CAD5:7D91).
• Server IP Address 2 to 4 or Server IPv6 Address 2 to 4—Up to three IPv4 or IPv6
backup RADIUS server addresses. If authentication fails with the primary server, each
configured backup server is tried in sequence.
• Key 1—The shared secret key that the WAP device uses to authenticate to the primary
RADIUS server. You can use up to 63 standard alphanumeric and special characters.
The key is case sensitive and must match the key configured on the RADIUS server.
The text you enter is shown as asterisks.
• Key 2 to Key 4—The RADIUS key associated with the configured backup RADIUS
servers. The server at Server IP (IPv6) Address 2 uses Key 2, the server at Server IP
(IPv6) Address 3 uses Key 3, and so on.
• Locale Count—The number of locales associated with the instance. You can create and
assign up to three different locales to each CP instance from the Web Customization
page.
• Delete Instance—Deletes the current instance.
Click Save. Your changes are saved to the Startup Configuration.
Server). However, you can configure each instance to use a
9
143