Table of Contents
Advertisement
CARE & MAINTENANCE
REGULAR CARE OF THIS RESTRAINT:
Please check the following items regularly to ensure the safety of your child:
A. Check the webbing straps for fraying,
B. Check there are no cracks in moulding,
C. Check the harness adjuster is operating and is clamping the webbing,
D. Ensure the buckle is free of fluff, liquid or other matter that may enter the buckle slots.
Clean the buckle if it is sluggish to engage. See next page.
E. If any part of the restraint is cracked, broken or not operating seek repair immediately
- contact Britax Customer Service 1300 303 330
CLEANING CAR SEAT
HARDWARE: Use only mild soap to clean all metal and plastic parts of your child
restraint, using a damp sponge or cloth. Do not use chemicals or cleaning agents. Do
not try and place any hardware into a washing machine.
STRAPS/HARNESS: We recommend spot cleaning straps and harness with a damp
sponge or cloth using only cold or warm water. Never place any straps or harness into a
washing machine or tumble dryer.
50
Instructions for Installation & Use
CARE & MAINTENANCE
BUCKLE OPERATION
To ensure the buckle remains operational the inside of the buckle must be kept free of
liquids, sand, dirt, fluff, food or similar substances. If the buckle is not operating or you
do not hear a strong audible click when second tongue is inserted then the buckle needs
to be washed or replaced. The buckle is fully engaged when both tongues are inserted .
Contact Customer Service for assistance.
TO CLEAN HARNESS BUCKLE:
If sticky liquids such as baby formula, fruit juice, etc. get
inside your harness buckle, it may become sluggish. An
indication of a sluggish harness buckle is that you cannot
hear a click when engaging the last harness tongues. To
restore the harness buckle to good working order it needs to
be cleaned as follows:
A. Remove the harness buckle from the restraint: From the
underside of the restraint pull each crotch strap 3-bar
slide, turn the 3-bar slide on its side and push back
through the slot.
B. Place the harness buckle under warm (max. 40 degrees
Celsius) running water as shown below. Let the water run
through the mouth of the buckle for five minutes. Check
the harness buckle is clean by engaging the harness
tongues and buckle several times until you hear a click.
C. If you still cannot hear a strong audible click then repeat
the cleaning process several times.
D. Refit the harness buckle to the restraint ensuring the red
button facing outwards and the 3-bar slide is fed through
the same slots.
If the Harness Buckle cannot be returned to its
original working condition then contact BRITAX
Customer Service for assistance.
Cover
Body
3-bar
A
slide
B
Click
C
51
Instructions for Installation & Use
Advertisement
Table of Contents
