Setup Mode Entering The Setup Mode At Installation - Intermec easycoder f2 Installation & Operation Manual

Setup Mode
Entering
Setup Mode
at Installation
Intermec EasyCoder F2 – Installation & Operation Ed. 2
The method of entering the Setup Mode depends on whether the
printer is fi tted with some kind of startup fi le, a subject that was more
thoroughly discussed in the chapter 4 "Starting Up" earlier in this
manual, to which the alphabetic references below refer.
A. EasyCoder F2 with Intermec Shell
• Turn on the power.
• When the display shows the message "Enter=Shell; x sec. ",
press <Enter>.
• Press the < Setup> key (this facility can be used anywhere
within Intermec Shell).
• Set up the printer as described in this chapter.
• Return to Intermec Shell by pressing the < Setup> key.
B. EasyCoder F2 with a custom-made application program
• Normally, there will be no need to enter the Setup Mode
for custom-made application programs. Necessary provisions
for changing the setup, manually or automatically, should be
provided by the program.
Chapter 7
53