Setup Mode; Entering The Setup Mode At Installation - Intermec EasyCoder F2 User Manual

Setup Mode

Entering Setup Mode at Installation
Intermec EasyCoder F2 – User's Guide
The method of entering the Setup Mode depends on which startup
fi les are stored in the printer's memory, a subject that was more
thoroughly discussed in Chapter 3, "Starting Up."
EasyCoder F2 with Intermec Shell
• Switch on the power.
• When the display shows the message "Enter=Shell; x sec...",
press <Enter>.
• Press <Setup> (this facility can be used anywhere within
Intermec Shell).
• Set up the printer as described in this chapter.
• Return to Intermec Shell by pressing <Setup>.
EasyCoder F2 with a custom-made application program
• Normally, there is no need to enter the Setup Mode for
custom-made application programs. Necessary provisions for
changing the setup, manually or automatically, should be
provided by the program.
Chapter 7
53