Entering Setup Mode At Installation - Intermec EasyCoder PF2i User Manual

Chapter 7 — Setup Mode

Entering Setup Mode at Installation

68 EasyCoder PF2i Bar Code Label Printer User's Guide (Fingerprint Version)
The method of entering the Setup Mode depends on which
startup files are stored in the printer's memory, a subject that was
more thoroughly discussed in
EasyCoder PF2i with Intermec Shell
• Switch on the power.
• When the display shows the message "Enter=Shell; x sec...",
press the Enter key.
• Press the Setup key (this facility can be used anywhere within
Intermec Shell and also outside Intermec Shell provided there
is no application program running that disables the Setup
key).
• Set up the printer as described in this chapter.
• Exit the Setup Mode by pressing the Setup key.
EasyCoder PF2i with a custom-made application program
Normally, there is no need to enter the Setup Mode when using
application programs that start up automatically. Necessary
provisions for changing the setup, manually or automatically,
should be provided by the program.
"Starting Up" on page 19.