Easycoder 201 Iie & 201 Iisa Entering The Setup Mode At Installation; Technical Manual - Intermec EasyCoder 201 II Technical Manual

Intermec EasyCoder 201 II – Technical Manual
SETTING UP EASYCODER 201 IIE & 201 IISA, cont'd.
Entering the Setup Mode
at Installation
The method of entering the Setup Mode depends on whether the
printer is fitted with some kind of startup file, a subject that was
more thoroughly discussed in the chapter "Starting Up" earlier in
this manual, to which the alphabetic references below refer.
A. EasyCoder 201 IIE with Intermec Shell:
• Turn on the power.
• When the display shows the message "Enter=Intermec Shell; x
sec.", press < Enter >.
• You can change any setup parameter via the Terminal Setup
option in Intermec Shell.
• You can also set up the printer by means of its built-in keyboard.
Press the < Setup > key (this facility can be used anywhere within
Intermec Shell).
• Set up the printer as described in this chapter.
• Return to Intermec Shell by pressing the < Setup > key.
B. EasyCoder 201 IISA:
• Turn on the power.
• In the Set Mode of the Intermec Stand-Alone program, select the
"Setup" option and then the "Printer" option.
• Set up the printer as described in this chapter.
• Exit to the Intermec Stand-Alone program by pressing < Save >.
C. EasyCoder 201 IIE with no startup file installed:
• Turn on the power.
• In the immediate mode of Intermec Fingerprint, press the
< Setup > key.
• Set up the printer as described in this chapter.
• Exit to the immediate mode of Intermec Fingerprint by pressing
the < Setup > key.
D. EasyCoder 201 IIE with a custom-made application program:
• Normally, there will be no need to enter the Setup Mode for
custom-made application programs. Necessary provisions for
changing the setup, manually or automatically, should be pro-
vided by the program.
33