Cleaning The Paper Guides - Intermec easycoder f2 Installation & Operation Manual

Cleaning the
Paper Guides
1
Lift the inner part of the upper guide and
pull it outwards,disengaging it from the lower
guide. Take care not to damage the cable.
Intermec EasyCoder F2 – Installation & Operation Ed. 2
Both parts of the label stop sensor, which controls the paper feed, are
covered by plastic guides. The guides are provided with seemingly
non-transparent areas, through which the light between the two
parts of the label stop sensor is transmitted. These areas (indicated
by a shade of grey in illustration #2 below) must be kept clean from
dust, stuck labels, and adhesive residue.
If the printer starts to feeed our labels in an unexpected way. lift the
upper guide – as described below – and check for anything that may
block the beam of light (dust, stuck labels, adhesive residue etc.).
If necessary, clean the guides using a cleaning card or a soft cloth
soaked with isopropyl alcohol. Do not use any other the of chemical.
Be careful not to scratch the guides.
Caution!
Isopropyl alcohol [(CH
fl ammable, moderately toxic and mildly irritating substance.
2
Tilt the upper guide upwards and clean the
areas marked with grey. After cleaning, reas-
Chapter 11 Maintenance
) CHOH; CAS 67-63-0] is a highly
3 2
semble in reverse order.
79