Panasonic AW-HE870N Operating Instructions Manual page 84

Menu item setting/changing (User Mode)
 Component output setting
[Component: RGB, Y/Pb/Pr, Y/C]
This enables RGB, Y/Pb/Pr or Y/C to be selected as
the component signals which are to be output from the
I/F REMOTE connector.
Y/C cannot be selected when "1080i" or "720p" has been
selected as the "Video output format (Format)" setting.
If "1080i" or "720p" has been selected using the video
output format selection function while Y/C is selected, the
component output will be changed to Y/Pb/Pr.
(Refer to "Changing the component setting" on page 87.)
 AWB/ABB operation status display ON/OFF
selection
[Status: Off, On]
(Factory setting: Off)
Using this item, the display of the operation status for
AWB (auto white balance adjustment) or ABB (auto black
balance adjustment) is set to ON or OFF.
When AWB or ABB is executed with this item set to "On",
the following is displayed.
AWB ACTIVE:
AWB OK:
AWB NG:
OUT RANGE RB: This is displayed for 3 seconds after
HIGH LIGHT NG: This is displayed for 3 seconds when
LOW LIGHT NG:
ABB ACTIVE:
ABB OK:
IRIS CONTROL NG:
OUT RANGE RGB: This is displayed for 3 seconds after
- 84 -
This is displayed while AWB is being
executed.
This is displayed for 3 seconds after
AWB was completed successfully.
This is displayed for 3 seconds after
AWB was not completed successfully.
(AWB executed while ATW, 3200K, or
5600K is selected)
AWB was not completed successfully.
(A color that could not be adjusted is
displayed with RB)
adjustment is not possible because
the light quantity is too high.
This is displayed for 3 seconds when
adjustment is not possible because
the light quantity is too low.
This is displayed while ABB is being
executed.
This is displayed for 3 seconds after
ABB was completed successfully.
This is displayed for 3 seconds when
the iris cannot be controlled by ABB.
ABB was not completed successfully.
(A color that could not be adjusted is
displayed with RGB)