Panasonic AW-HE870N Operating Instructions Manual page 21

Mounting
 Example where the camera is mounted on a ceiling or wall
(Ceiling)
Flat washers
Spring washers
Mounting screws
(Inch screws: 1/4-20UNC)
Notes
 When attaching one end of the drop-prevention wire to the
surface of a ceiling or wall, ensure that it is strong enough to bear
at least five times the total weight including the mounting bracket
or other part.
 Tighten the mounting screws and mounting spacers using the
torque levels shown in the table to the right, and then check for
play and unsteadiness.
The connection and installation should be done by qualified service personnel
or system installers. Refer any servicing to qualified service personnel.
Hitch the end of the wire
onto the anchor bolt by
tightening the nut or
screw or by using a hook.
Mounting screw (M4)
Drop-prevention wire
Mounting spacer
(supplied)
Camera mounting
bracket
(Wall)
Hitch the end of the wire
onto the anchor bolt by
tightening the nut or
screw or by using a hook.
Drop-prevention wire
Mounting screw (M4)
Mounting spacer
(supplied)
Flat washers
Spring washers
Mounting screws
(Inch screws: 1/4-20UNC)
Screws/Spacer
Mounting screws (M4)
Mounting screws (Inch screws)
Mounting spacer
- 21 -
Camera mounting
bracket
Clamping torque
1.5N • m (15 kgf • cm)
2.0N • m (20 kgf • cm)
2.0N • m (20 kgf • cm)