Panasonic AW-HE870N Operating Instructions Manual page 14

Precautions for installation
Parts to be provided by the customer for installation
Provide the following parts when the unit is to be mounted
onto a surface other than a pan-tilt head.
When the unit is to be mounted onto a Panasonic pan-tilt
head, use the mounting screws and drop-prevention wire
that are supplied with the pan-tilt head.
 Drop-prevention wire: 1
Either crimp the two ends of the wire using stainless steel
terminals or attach metal hooks to the two ends of the
wire. Use a wire that is sufficiently strong.
Consider the installation location and mounting method
to be used, and cut the wire to a length that will have no
slack when attached.
Wire length
( Camera
side)
ø4.2
8.5 mm
Stainless steel wire
Shape the end of the wire so that it can be
attached using an M6 or M8 bolt and nut.
 Provide the bolt and nut or anchor bolt
that is best suited for the installation
location and mounting method used.
ø1.2 or more
(Hook type)
(Crimping type)
The connection and installation should be done by
qualified service personnel or system installers.
Refer any servicing to qualified service personnel.
 Mounting screws (M4): 1
(For attaching the drop-prevention wire)
Determine the length of
this screw by factoring
in the thickness of the
drop-prevention wire's
terminal.
 Mounting screws (Inch screws: 1/4-20UNC): 2
(For mounting the camera)
Determine the length of
these screws by factoring
in the thickness of the
camera mounting bracket.
 Flat washers: 2 (For mounting the camera)
 Spring washers: 2 (For mounting the camera)
 Camera mounting bracket: 1
Provide a bracket of a material and shape sufficiently
capable of withstanding the total weight to be borne.
To determine the position of the holes used for mounting
the camera, refer to <Bottom view> on page 15, and
make holes with a diameter of 7 mm (to support 1/4-
20UNC mounting screws).
- 14 -
Drop-prevention wire
5 mm
Camera mounting
bracket
8 mm