Removing The Idsdm Card - Dell PowerEdge M830 Owner's Manual

Figure 22. Installing the internal USB memory key
1. USB memory key
Next steps
1. Follow the procedure listed in the After working inside your system section.
2. While booting, press F2 to enter System Setup and verify that the system detects the USB memory
key.

Removing the IDSDM card

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: You must remove the IDSDM card to replace a faulty IDSDM card or service other
components inside the system.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the #2 Phillips screwdriver ready.
4. Remove the mezzanine card.
5. If installed, remove the internal USB key.
6. If installed, remove the SD card(s).
Steps
1. Remove the two screws securing the IDSDM card to the system board.
2. Remove the SD card slot bracket.
CAUTION: To prevent damage to the IDSDM card, hold the card only by its edges.
3. Lift the card away from the system.
2. USB port
85