Dell PowerEdge M830 Owner's Manual page 93

NOTE: You must remove the NDC to replace a faulty NDC or service other components inside the
system.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the #2 Phillips screwdriver ready.
4. Remove the mezzanine card.
Steps
1. Remove the two screws that secure the Network Daughter Card (NDC) to the system board.
CAUTION: To prevent damage to the NDC, hold the card only by its edges.
2. Lift the card away from the system.
Figure 29. Removing the NDC
1. slot on the NDC
3. NDC
5. connector
Next steps
1. Install the NDC.
2. Follow the procedure listed in the After working inside your system section.
2. screw (2)
4. standoff (2)
6. tab projections
93