Internal Usb Key - Dell PowerEdge M830 Owner's Manual

Steps
1. Locate the SD card slot on the internal dual SD module (IDSDM) card.
2. Press inward on the card to release it from the slot, and remove the card.
Figure 20. Replacing an SD card
1. IDSDM card
3. upper card slot (SD 2)
Next steps
1. Follow the procedure listed in the After working inside your system section.
2. Enter the System Setup and ensure that the Internal SD Card Port and Internal SD Card
Redundancy modes are enabled.
3. Check if the new SD card is functioning properly. If the problem persists, see the Getting Help
section.
Related Links
Safety instructions
Before working inside your system
After working inside your system
Getting help

Internal USB key

The blade provides an internal USB connector for a USB flash memory key. The USB memory key can be
used as a boot device, security key, or mass storage device. To use the internal USB connector, the
Internal USB Port option must be enabled in the Integrated Devices screen of the System Setup.
To boot from the USB memory key, you must configure the USB memory key with a boot image, and
then specify the USB memory key in the boot sequence in the System Setup. For information on creating
a bootable file on the USB memory key, see the user documentation that accompanied the USB memory
key.
2. SD card
4. lower card slot (SD 1)
83